How to Properly Load a SPVR5400 with a RS232 cable

NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable 
Or RCA cables !! FAILURE to do so WILL damage your receiver !

1) WRITE down ALL dish settings Before you start these steps !

2) Download and unzip the (New Firmware(s)) with latest release.

3) Connect your receiver to your computer using your RS232 cable.

4) Open Loader click the file button and load your new Firmware into your loader.

5) Make shure that your Receiver is in (Standby) now click on OK on your loader, 
   Now click on OK to start your Receiver from (Standby) 
5a) You can load Firmware from Standby
    You can load Settings from Standby
    you can load new kxxs from Standby

6)When your receiver reboots itself click Menu on your remote and then go to 
Installation screen and select FACTORY SETTING and click YES to 
(Reset all settings)
WARNING ! Make shure that you have a BACKUP OF YOUR SETTINGS

7)Now Repeat the First 6 steps to load the New Firmware bin !

8) Re-Load your Settings and then do a AUTO Scan on your selected satilites for New Programms

9) You can also Download using the Standby ( as in 5a )

NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your 
Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !



















(C) F